|
ServoWorks S-100T Supported M Codes
- Program stop (M00)
- Optional stop (M01)
- Program end/program end and rewind (M02/M30)
- Spindle CW (M03)
- Spindle CCW (M04)
- Spindle stop (M05)
- Coolant on/off (M08, M09)
- Chuck unclamp/clamp, collet open/close (M10, M11)
- Indexing – spindle orientation, spindle rotation mode (M19, M20)
- Live tools control (M50 – M55)
- Subprogram calls (M98/M99)
- Up to 82 customizable M codes through PLC
ServoWorks S-100T Supported G Codes
- G00 Positioning (rapid traverse)
- G01 Linear interpolation
- G02, G03 CW/CCW circular interpolation
- G04 Dwell
- G09 Exact stop check
- G10 Programmable data input
- G20, G21 Inch/metric data input
- G22, G23 Barrier check on/off
- G25, G26 Spindle speed fluctuation detection off/on
- G28, G29 Automatic zero return to/from the reference point
- G30 Automatic zero return to the 2nd, 3rd & 4th reference points
- G32 Thread cutting with a constant lead
- G40-G42 Tool nose radius compensations
- G50 Coordinate system preset and maximum spindle RPM
- G52 Local coordinate preset
- G53 Machine coordinate selection
- G54-G59 Workpiece coordinate selection
- G61 Exact stop check mode
- G64 Cutting mode
- G65 Simple macro call
- G70 Finishing cycle
- G71, G72 Stock removal in turning/facing
- G73 Pattern repeat cycle
- G74 End face peck drilling/grooving
- G75 Outer diameter/inner diameter grooving
- G76 Multiple-pass threading cycle
- G80 Hole machining canned cycle cancel
- G83 Face drilling cycle
- G84 Face tapping cycle
- G85 Face boring cycle
- G87 Side drilling cycle
- G88 Side tapping cycle
- G89 Side boring cycle
- G90 Outer diameter/inner diameter cutting cycle
- G92 Thread cutting cycle
- G94 End face cutting cycle
- G96, G97 Constant surface speed control set/cancel
- G98, G99 Per minute/per revolution feed
- G107 Cylindrical interpolation
- G112, G113 Polar coordinate interpolation mode set/cancel
- G164 Continuous cutting mode
Last revision 10/31/06
|